Description: The LCD is missing characters or parts of characters
Causes: The LCD may need replacing.
Remedy: Run the Power-On Self Test on page 117 and check that the LCD display shows all characters. If not, replace the LCD.
Code: 32
Display:
Description: Changes in parameter settings did not take effect
Causes: Parameters are set incorrectly. A command turned off the ability to change the parameter. A command changed the parameter back to the previous setting. If the problem continues, there may be a problem with the main logic board.
Remedy: 1. Set parameters and save permanently. 2. Turn the printer off (O) and then on (I). Refer to the ZPL Programming Guide. Refer to the ZPL Programming Guide. Replace the main logic board.
Code: 33
Display:
Description: The printer fails to calibrate or detect the top of the label.
Causes: The printer was not calibrated for the label being used. The printer is configured for continuous media. The driver or software configuration is not set correctly.
Remedy: Perform the calibration procedure in Calibrate Media and Ribbon Sensor Sensitivity on page 90. Set the media type to noncontinuous media. See Set Media Type on page 81. Driver or software settings produce commands that can overwrite the printer configuration. Check the driver or software media-related setting.
Code: 34
Display:
Description: Non-continuous labels are being treated as continuous labels.
Causes: The printer was not calibrated for the media being used. The printer is configured for continuous media.
Remedy: Perform the calibration procedure in Calibrate Media and Ribbon Sensor Sensitivity on page 90. Set the media type to noncontinuous media. See Set Media Type on page 81.
Code: 35
Display:
Description: All lights are on, but nothing displays on the LCD, and the printer locks up.
Causes: Internal electronic or firmware failure.
Remedy: Turn the printer power off (O) and then on (I). If the printer locks up again, replace the main logic board.
Code: 36
Display:
Description: The printer locks up while running the Power-On Self Test.