Description: All LEDs light, but nothing displays on LCD and printer does not operate.
Causes: Main logic board or Flash faulty.
Remedy: Download new Flash or replace the main logic board.
Code: 02
Display:
Description: All LEDs flash.
Causes: No significant amount of DRAM tested good.
Remedy: Replace the main logic board.
Code: 03
Display:
Description: Take-Label LED flashes.
Causes: Printer misconfigured for Peel-Off Mode.
Remedy: If peel-off is desired, check Take-Label sensor.
Code: 04
Display:
Description: Printer locks up while running Power-On Self Test.
Causes: Main logic board failure.
Remedy: Replace the main logic board.
Code: 05
Display: EEPROM checksum invalid
Description:
Causes: EEPROM checksum is incorrect.
Remedy: Replace the main logic board.
Code: 06
Display: ERROR CONDITION PAPER OUT
Description:
Causes: No media loaded or incorrectly loaded. Misadjusted media sensor. Maximum label length set shorter than label length. Printer set for non-continuous media, but continuous media is loaded.
Remedy: Load media correctly. Check media sensor position and sensitivity. Verify maximum label length setting is correct. Install proper media or reset printer for current media type.