Xerox Phaser 860

• Code: 07,003.45
• Display: 07,003.45: PM_FAULT_ COMPOUND_ GEAR_SENSOR_BAD
• Description: No transistions are observed for the compound gear sensor, when the compound gear should be turning. Verify that compound gear sensor is not physically broken and is plugged in to the left I/O board. Run diagnostics to verify operation or change the sensor.

• Code: 07,004.46
• Display: 07,004.46: PM_FAULT_DM_CAM_ State_Error
• Description: The Drum Maintenance home sensor did not actuate or change state as expected. Run diagnostics to verify clutch and sensor operation. Also verify that the shaft is properly assembled.

• Code: 07,005.47
• Display: 07,005.47 PM_FAULT_DM_CAM_ POSITION_ERROR
• Description: The Drum Maintenance home sensor actuated, but not at the expected time. Inspect the maintenance drawer lift pins for wear. Run diagnostics to verify clutch and sensor operation. Also verify that the drum maintenance shaft is properly assembled.

• Code: 07,006.48
• Display: 07,006.48 PM_FAULT_DM_CAM UNEXPECTED_MOTION
• Description: The Drum Maintenance home sensor actuated, when no motion should have occurred. Run diagnostics to verify clutch and sensor operation. Also verify that the shaft is properly assembled.

• Code: 08,001.44
• Display: 08,001.44: CAP_FAULT_HOME_ SENSOR
• Description: The cap-home sensor did not see the sensor’s flag when expected. The home sensor may be faulty, or the paper- feed motor may not be operating. The cap/wipe/purge clutch may be failing, or the assembly may be jammed and unable to move. Inspect check the paper-exit drive belt and the gear on the right end of the duplex roller shaft next to the paper path motor. Ensure that the paper path is free of media. For the Phaser 860 only, run the Cap Axis Geometry and Cap Axis Drive diagnostic tests.

• Code: 08,003.46
• Display: 08,003.46
• Description: The cap-home sensor was activated too soon. This can occur if the cap/wipe/purge assembly was obstructed while moving up and therefore retruned to the home position too soon. Ensure that the head tilt mechanism is working properly. Run diagnostics to verify cap drive motion and alignment.