Description: Drive Roller encoder problem. Problem finding the Drive Roller zero.
Remedy: • Perform the Driver Roller service test .
Code: 86:01
Description: Carriage servo shutdown. There is a problem with the carriage assembly.
Remedy: • Open the Window observing all safety precautions and check for any visible obstacles restricting the movement of the Carriage Assembly. If there is a wrinkled mass of media inside the paper path, lift the Pinchwheels (using the Media Lever) and clear the obstruction. • Check that the Carriage Stopper is correctly installed Ëpage 412. • Perform the gScan Axish Diagnostic , depending on the result of the test, you may need to replace the following parts: • Scan Axis Motor Ëpage 419. • Encoder Strip Ëpage 399. • Check the cables are correctly connected between the PrintMech PCA and the Scan Axis Motor. • If the error continues, replace the Scan Axis Motor .
Code: 93:11
Description: Unable to pressurize the IDS. The IDS must be pressurized but the requested pressure is not achievable in the time given (120 seconds).
Remedy: • Perform the APS service test ËPage 146 • Check the air pumps are correctly connected. • Check the cables from the PrintMech to the Air Pump are connected and not damaged. • Check that the air tubes connected to the air pressure sensor are not pinched and are correctly connected. • Check that the air tubes are connected, as this issue could cause this system error to be displayed • Check the Primer air tubes are connected and not damaged. • Tap on the relief valve with a screw driver several times to release it from a pressure blockage. • Remove ALL the Ink Cartridges and reinstall them one by one in to the Printer. • Replace the APS Assembly . • Replace the ISS PCA