Causes: • If neither of the Jump wing sw1 or sw2 has been depressed within 5 seconds after the Wing motor was activated. • If neither of the Jump wing sw1 or sw2 has been released within 5 seconds after the Wing motor was activated.
Remedy: Press <ALL RESET> key.
Code: T3
Description: Clamp Error (1)
Causes: • In 4 seconds from turning ON of the Clamp solenoid in clamp retrial, the Clamp safety switch is held still pressed down. • In 4 seconds from turning OFF of the Clamp solenoid, the Clamp safety SW has not been pressed. • In 8 seconds from turning ON of the Clamp motor in opening direction in clamp retrial, the 180° Angular sensor has not detected magnet. • In 8 seconds from turning ON of the Clamp motor in closing direction in clamp retrial, the 0° Angular sensor has not detected magnet. In any of the above cases, master making is performed to the end.
Remedy: Press <ALL RESET> key. Press <START> key.
Code: T30
Description: P. -F. Tray Slide Pulse Motor
Causes: • When the Paper feed tray position sensor is not turned on/ off within 165 pulses(approx. 3 second) after the P. -F. tray slide pulse motor is turned on.
Remedy: Press <ALL RESET> key.
Code: T4
Description: Overflow
Causes: • When ink is in contact with the Overflow sensor. The Drum set switch need be pushed.
Remedy: Overflow sensor OFF <CLEAN>
Code: T5
Description: Print Positioning Motor Lock
Causes: • In 12 seconds from turning ON of the Print positioning motor, the Vertical centering sensor is not turned ON/OFF.
Remedy: Press <ALL RESET> key.
Code: T50
Description: Connect “Copy/Master” Counter
Causes: • When the copy counter or the master counter has not been connected.
Remedy: Electromagnetic counter setting signal L (Connect an electromagnetic counter.)