PrintCopy.info service

Zebra 170XiIII plus

Error Codes List page 1

  • Code: 01
  • Display:
  • Description: All LEDs light, but nothing displays on LCD and printer does not operate.
  • Causes: Main logic board or Flash faulty.
  • Remedy: Download new Flash or replace the main logic board.
  • Code: 02
  • Display:
  • Description: All LEDs flash.
  • Causes: No significant amount of DRAM tested good.
  • Remedy: Replace the main logic board.
  • Code: 03
  • Display:
  • Description: Take-Label LED flashes.
  • Causes: Printer misconfigured for Peel-Off Mode.
  • Remedy: If peel-off is desired, check Take-Label sensor.
  • Code: 04
  • Display:
  • Description: Printer locks up while running Power-On Self Test.
  • Causes: Main logic board failure.
  • Remedy: Replace the main logic board.
  • Code: 05
  • Display: EEPROM checksum invalid
  • Description:
  • Causes: EEPROM checksum is incorrect.
  • Remedy: Replace the main logic board.
  • Code: 06
  • Display: ERROR CONDITION PAPER OUT
  • Description:
  • Causes: No media loaded or incorrectly loaded. Misadjusted media sensor. Maximum label length set shorter than label length. Printer set for non-continuous media, but continuous media is loaded.
  • Remedy: Load media correctly. Check media sensor position and sensitivity. Verify maximum label length setting is correct. Install proper media or reset printer for current media type.
Error Code
Service Mode, Troubleshooting
Parts Catalog
Downloads Files
Home
New Register Forgot Password?
Send message to us