Description: Paper Jam in Duplex Area Fault The machine has detected a paper jam in the Duplex Area.
Remedy: Check the Exit Sensor Actuator. The actuator moves freely. Replace the Exit Sensor Actuator. Enter Diagnostics (EDC) Mode. Select: [DC330 Component Control, 102-Sensor, Out Bin Exit Sens] to test the Exit Sensor. The sensor is OK. Replace the Exit Sensor. Check the following parts for wear or damage and replace if needed: • Duplex Paper Guide • Duplex Gate • Duplex Gate Spring • Duplex Gate Mounting • Paper Guide on Rear Cover Make certain that the Duplex Gate is seated correctly and moves freely without binding.
Code: 08-700
Description: Output Tray Full Fault The Output Tray Full Sensor has detected that the Output Tray is full.
Remedy: Enter Diagnostic (EDC) Mode. Select: [DC330 Component Control, 102-Sensor, Out Bin Full] to test the Out Bin Full Sensor. The signal changes. • Check that the sensor connector is firmly seated. • Replace the Out Bin Full Sensor. Check actuator for binding. If the problem is intermittent, replace the Out Bin Full Sensor Actuator.
Code: 09-100
Description: Toner Cartridge Near End of Life Fault The Toner Cartridge life is less than 10%.
Remedy: 1. Check the remaining life of the Toner Cartridge by using one of the methods listed below: • Print a Supplies Information Report. [GP 2] • Open Easy Printer Manager, check Toner Life. • Open the CWIS application. Select; [Status, Supplies, Print Cartridge]. 2. Check the remaining life of the Toner Cartridge. 3. If the Toner Cartridge has reached end of life, switch Off the power and replace the Toner Cartridge.
Code: 09-300
Description: Imaging Unit Near End of Life Fault The Imaging Unit life is less than 10%.
Remedy: 1. Check the remaining life of the Toner Cartridge by using one of the methods listed below: • Print a Supplies Information Report. [GP 2] • Open Easy Printer Manager, select [Machine Status] • Open the CWIS application. Select; [Status, Supplies, Black Imaging Unit]. 2. Check the remaining life of the Imaging Unit. 3. If the Imaging Unit has reached end of life, switch Off the power and replace the Imaging Unit.
Code: 09-350
Description: Toner Cartridge End of Life Fault The Toner Cartridge has reached end of life.
Remedy: 1. Check the remaining life of the Toner Cartridge by using one of the methods listed below: • Print a Supplies Information Report. [GP 2] • Open Easy Printer Manager, check Toner Life. • Open the CWIS application. Select; [Status, Supplies, Print Cartridge]. 2. Check the remaining life of the Toner Cartridge. 3. If the Toner Cartridge has reached end of life, switch Off the power and replace the Toner Cartridge.
Code: 09-400
Description: Imaging Unit End of Life Fault The Imaging Unit has reached end of life.
Remedy: 1. Check the remaining life of the Imaging Unit by using one of the methods listed below: • Print a Supplies Information Report. [GP 2] • Open Easy Printer Manager, select [Machine Status]. • Open the CWIS application. Select; [Status, Supplies, Black Imaging Unit]. 2. Check the remaining life of the Imaging Unit. 3. If the Imaging Unit has reached end of life, switch Off the power and replace the Imaging Unit.