Causes: Application license management database is damaged.
Remedy: 1. Perform HS-75 File System recovery mode > Initialize DB → AppLicense DB and then delete the journal file. 2. If the error is not recovered, reinstall the system software. (HS-49 Firmware update mode > System Software(HD data))
Code: F128
Description: License management database damage
Causes: The license management database stored in the HDD has been damaged.
Remedy: Reboot the equipment. When a 71E0 error has appeared, perform its troubleshooting. If an F128 error has appeared again, perform the following procedure. (1) Open HS-[75 File System Recovery]-[Initialize DB]. (2) Select [ULM DB] only and press [OK]. (3) Reboot the equipment. When a 71E0 error has appeared, perform its troubleshooting.
Code: F130
Description: Invalid MAC address
Causes: This error occurs when the top 3 bytes of the MAC address is not "00" "80" "91".
Remedy: Setting This error occurs when the top 3 bytes of the MAC address is not "00" "80" "91". SYS board Replace the SYS board
Code: F131
Description: Filtering setting file damage error
Causes: The filtering function is not working properly due to the damage to the file for the filtering setting.
Remedy: 1. Check the bad sector of the HDD (FS-08-9072). If the result is "NG", replace the HDD. Notes: It may take more than 30 minutes to finish the checking. 2. Perform HS-73 Assist mode -> Format HDD, and then reinstall the HDD software. Notes: User data will be deleted when HS-73 Assist mode - > Format HDD is performed.
Code: F140
Description: ASIC format abnormality
Causes: ASIC formatting fails when software is formatted
Remedy: SYS board • Connector check (CN129) Check if the connector is disconnected, the terminals are folded or there is any foreign matter. (When the DSDF I/F board installed, take it off to perform the check.) • Board check Check both front and back side of the board if there is an abnormality such as staining, foreign matter or scratches around IC29 (indicated in the figure below).
Code: F150
Description: Power failure during the manufacturing mode
Causes: When a power failure occurred during the manufacturing mode, this error code appears at the next startup.