Samsung CLX6220FX

• Code: 03-000
• Display: Motor error Error: #03-000 Turn off then on
• Description: Motor Signal is abnormal.
• Causes: 1. Harness is defective, Connector is not connected properly. 2. Main BLDC Motor is defective. 3. Main Board is defective.
• Remedy: 1. Replace Harness if defective. 2. Replace the Main BLDC Motor if defective. 3. Replace the Main Board if defective.

• Code: 03-007, 03-008, 03-009
• Display: Motor error Error: #03-007/008/009 Turn off then on
• Description: Motor Signal is abnormal.
• Causes: 1. Harness is defective, Connector is not connected properly. 2. Color OPC BLDC Motor is defective. 3. Main Board is defective.
• Remedy: 1. Check the motor connector. Reconnect the harness. 2. If the problem persists, replace the BLDC motor. 3. If the problem persists after replacing BLDC motor, replace the Main PBA.

• Code: 03-015
• Display: Motor error Error: #03-015 Turn off then on
• Description: Fan does not operate.
• Causes: Fan is defective.
• Remedy: 1. Check the CN17 connector (FAN) on Main PBA. 2. If the FAN is defective, replace it. 3. If the problem persists, replace the Main PBA.

• Code: 04-001, 04-002, 04-008
• Display: LSU error: #. Please turn off then on.A.
• Description: Laser beam detect signal has not occurred or is irregular. LSU motor does not operate.
• Causes: 1. Harness is defective, Connector is not connected properly. 2. LSU is defective. 3. Main Board is defective.
• Remedy: 1. Check the LSU connector on Main PBA. Reconnect it. If necessary, replace it. 2. If the problem persists, replace the LSU or Main PBA.

• Code: 08-000, 08-001
• Display: Original paper Jam Original paper jam inside of scanner. Remove Jam
• Description: The lead edge of the document failed to actuate the Registration sensor within the predetermined time after initialization of Paper Pick up.
• Causes: 1. Pick up roller is defective. 2. Scan sensor or actuator is defective. 3. Document paper path is contaminated.
• Remedy: 1. Check the paper path for a small piece of paper that may have been torn from an original; or foreign materials such as paper clips, extracted staples, etc. 2. Check the condition of the Pick-up, Paper Feed Roller and DADF Rubber, it may have reached its PM interval. 3. Registration Sensor change 4. Registration Sensor drive Board change 5. Pick-up Solenoid change

• Code: 08-002, 08-006
• Display: Original paper jam inside of scanner
• Description: The leadedge of the document has not reached to scan sensor after being sensed by the regi sensor.
• Causes: 1. Gate sensor or actuator is defective. 2. Document paper path is contaminated. 3. WHITE BAR SHEET is not attached properly. 4. WHITE BAR is defective.
• Remedy: 1. Check the paper path for a small piece of paper that may have been torn from an original; or foreign materials such as paper clips, extracted staples, etc. 2. Check that the White bar sheet is properly set to the guide. 3. Check and clean the Registration Roller, replace as is necessary. 4. Check and clean the Exit Roller, replace as is necessary. 5. Check and clean the Scan Senor for paper dust, replace as is necessary. 6. Check the signals from the Scan Sensor Drive Board, replace as is necessary. 7. Check and clean the Exit Solenoid, replace as is necessary.