Description: The operation is paused. - Press the VIEW key to cancel the View state.
Causes:
Code: n02
Display: MODELING MODE LED blinks in an interval of 0.1sec. SCANNING LED blinks in an interval of 0.1sec.
Description: Command Error SIO Error
Causes: Command cannot be recongnized. Serial Port Over-run Error. - First turn on the computer, then turn on MODELA. - Switch off the power, then check the cable connections and the port setting for the driver.
Code: n03
Display: Model LED blinks in an interval of 0.5sec.
Description: Spindle Lock Error
Causes: Too much load on the Spindle Motor. - Check the Cutter is not broken. - Select the suitable Engraving Parameters for the material.
Code: n04
Display: All LEDs blink in an interval of 0.5sec.
Description: Z UNIT ERROR
Causes: Z UNIT cannot be recongnized whether it is a SCAN UNIT or SPINDLE UNIT. The code comes loose from the SCAN UNIT or SPINDLE UNIT. - Reconnect the code.
Code: n05
Display: VIEW LED blinks in an interval of 1sec.
Description: The Front Cover is detached. - Install the Front Cover. When a sensor unit is installed, the VIEW LED does not blink.
Causes:
Code: n06
Display: Scan LED blinks in a sequence of ON (0.1sec) -> OFF (0.1sec) -> ON (0.1sec) -> OFF (0.3sec).
Description: R.A.P.S. Error
Causes: Auto-Tuning Error or Voltage is too low. - Switch off the power, then clean the Sensor. If the error is still exist, the Sensor Unit is defective.