Description: Network I/F Initialize has not been completed.
Causes: Network I/F does not work correctly. Firmware for Network I/F is not installed.
Remedy: Check if the firmware is installed into Network I/F. Main Board replacement
Code: 0101
Description: Limit Position Initialize in the Service Mode has not been done.
Causes: Limit Position Initialize has not been done. Limit Position Initialize is ended before it is completed.
Remedy: Complete Limit Position Initialize correctly.
Code: 0102
Description: Head Lock Sensor is ON when it should be OFF, or vice versa.
Causes: Head Lock Sensor does not work correctly or is broken. Head Carriage is not located at the correct position.
Remedy: Head Lock Sensor replacement Check the mechanical backlash or loose with the scan axis related parts.
Code: 0107
Description: Linear Encoder Setup has not been done.
Causes: Linear Encoder Setup has not been done. Linear Encoder Setup is ended before it is completed.
Remedy: Carry out Linear Encoder Setup in service menu
Code: 0109
Description: Wiper unit does not work correctly.
Causes: Wiper Motor error Defect of Wiper Unit Defect of Wiper Sensor Cut-line or short-circuit of cable and Flexible cable
Remedy: Wiper Motor Replacement Wiper Unit Replacement Wiper Sensor Replacement Cable and Flexible Cable Replacement
Code: 0110
Description: There is a problem in reading the Linear Encoder.
Causes: Read error of Linear Encoder. Read error of Encoder on Scan Motor side. Belt is not fixed to Head Carriage firmly.
Remedy: Confirm whether Encoder Scale is between the slit of Encoder Module in a whole width of the printer. Check cable connection between Linear Encoder Board and Head Board Confirm connection between Belt and Carriage Linear Encoder replacement Scan Motor replacement Servo Board replacement Main Board replacement