Causes: 001 Communication error with the digitizer CPU
Remedy: Switch power on again
Code: T08
Description: Computer interface error
Causes: 002 Communication error with the computer interface
Remedy: Switch power on again
Code: T09
Description: Option error (paper eject)
Causes: 003 Communication error with the sorter 700 Sorter communication: CTS does not switch to L within 3000 ms after the power is switched ON. 701 Sorter communication: The type status was not returned within 200 ms after the initialization command was sent. 710 Sorter communication: Transmission timeout 711 Sorter communication: CTS does not change. 712 Sorter communication: The retry command was sent but not received. 720 Sorter communication: The retry command was received two times in successtion.
Remedy: Switch power on again
Code: T10
Description: Option error (paper feed)
Causes: 800 The multi-tray unit is connected, but the power is OFF. 801 The type status was not returned from the multi-tray unit when the power was switched ON. 802 The Standby OK command was not returned when printing started. 803 The status was not returned from the multi-tray unit. 840 An undefined multi-tray-unit command was received. 841 CAN controller initialization failed.
Remedy: Switch power on again
Code: T11
Description: Pressure-control motor
Causes: 600 Timeout error for reducing pressure (OFF -> ON) during print-pressure home positioning 601 Timeout error for increasing pressure (ON -> OFF) during print-pressure home positioning 602 The print-pressure limit sensor does not change during print-pressure operation. 620 Print-pressure operation was called with the print-pressure motor locked. 621 Incorrect print-pressure operation timing (print-pressure operation command was received when the print-pressure should not change.) 622 Sensor A is ON and sensor B is OFF during movement from area A to area D. 623 Either sensor A or sensor B is ON during movement from area D to area A. 624 The current area data is undefined. 625 The target area data is undefined. 626 Timeout during relative print-pressure movement
Remedy: Jam reset or switch on power again
Code: T12
Description: Master-disposal-section motor lock
Causes: 300 Master-disposal-motor overload-current detection is ON. 305 The master compression sensor does not go ON within 6.5 s after the master compression motor operates in the return direction. 306 Master compression sensor does not go OFF within 2 s after the master compression motor operates in the compress direction. 307 The master compression sensor does not go ON within 6.5 s after the master compression motor operates in the compress direction, and the master-compression-motor limit sensor cannot count up until the compression-limit position. 309 The master-compression-motor limit sensor does not change within 200 ms during compression operation.