PrintCopy.info service

Riso RN2000

Error Codes List page 1

  • Code: A01
  • Description: Master feed error
  • Causes: 201 The master-positioning sensor does not go ON even when the master is fed the preset amount after the write pulse motor and load pulse motor are activated during the masterpositioning operation. 202 The master-positioning sensor does not go OFF even when the write pulse motor is reversed during the master-positioning operation. 211 The master-positioning sensor was ON during standby. 214 The master-positioning sensor was ON at the start of master making. 215 Faulty gate-array control for the write pulse motor or load pulse motor
  • Remedy: Master-making-unit sensor: OFF -> ON, then master-positioning sensor OFF (or switch the power on again)
  • Code: A02
  • Description: Master loading error
  • Causes: 509 The master-loading sensor was OFF when the master was checked at a specified angle during the master-loading operation.
  • Remedy: Master-manufacturing unit sensor: OFF -> ON
  • Code: A03
  • Description: Cutting error
  • Causes: 206 Cutting was performed after the cutting operation was repeated.
  • Remedy: Print-drum set sensor: OFF -> ON
  • Code: A04
  • Description: Master-disposal error
  • Causes: 303 OFF/OFF in master-disposal jam sensor check at 120°/180° 304 The master-disposal jam sensor was ON upon completion of master-disposal operation.
  • Remedy: Print-drum set sensor: OFF -> ON
  • Code: A05
  • Description: Master present in the master-disposal section
  • Causes: 312 The master-disposal jam sensor was ON at the start of master making operation.
  • Remedy: Master-disposal-unit set sensor: OFF C25-> ON, and master-disposal jam sensor: ON (Or switch the power on again.)
  • Code: A06
  • Description: Check paper-feed tray
  • Causes: 403 The paper-feed-tray upper or lower safety switch was OFF.
  • Remedy: The paper-feed-tray lower/upper safety switch goes ON. (Or switch the power on again.)
Service manual
Error Code
Parts Catalog
Compatibility
Home
New Register Forgot Password?
Send message to us