Causes: 103 Original jammed under Original IN sensor. 107 Original does not arrive to the Original IN sensor.
Remedy:
Code: A16
Description: Waiting for the master to be removed from the drum
Causes: 525 Waiting for the master to be removed from the print cylinder (drum).
Remedy: Pull out the print cylinder (drum), remove the master around it and insert it back.
Code: A17
Description: Cutter error
Causes: 205 Master positioning sensor is ON after master cutting and Print drum returns back to Position-A. (Master cut error) 209 Cutter HP switch is OFF when master making started or when the master material was set.
Remedy: Open the Master making unit, remove the master and close the master making unit.
Code: A34
Description: Requesting for the master to be reset
Causes: 206 When the Master making unit safety switch turned from OFF to ON, the Master position sensor was ON. (Master setting error) 218 Requesting for the leading edge of the master material to be set in the master making unit.
Remedy: Open the Master making unit, re-insert the master material into the master making unit.
Code: C01
Description: Replace ink cartridge
Causes: 512 The ink sensor did not go ON even when inking was performed for a preset duration. (No ink detected.) 563 Ink remaining amount is zero from the information on the RF-Tag. 574 Inkless error was detected 5 times consecutively on one same ink cartridge.
Remedy: Remove the empty ink cartridge and replace with a new one.
Code: C02
Description: Replace master roll
Causes: 200 The master end was detected twice in succession at 10-milliseconds intervals during master transport. (Master material is fully used from the master roll.) 240 Master remaining amount is zero from the RF-Tag information. 253 Masterless error was detected twice consecutively on one same master-roll.
Remedy: Remove the empty master roll and replace with a new one.