Causes: 201 Master-positioning sensor does not go ON even after the write pulse motor is activated during the master-positioning, master-cut, or master-loading operation. 258 Master end tape detected twice in a row.
Remedy: Open the master-making unit and rewind the master material on the master roll, and then reset the master, or turn OFF the power and power back ON.
Code: A02
Description: Master loading error
Causes: Pull out the print cylinder and set it back.
Remedy: 509 Master-loading sensor was OFF when the master was checked at a specified drum angle during the master-loading operation.
Remedy: Pull out the print drum and push it back in.
Code: A05
Description: Master present in the master disposal area
Causes: 304 Master disposal box check request after master removal error or master disposal jam. 312 Master disposal jam sensor was ON at the start of the master making.
Remedy: Pull out master disposal box and place it back after removing the jammed master in the master disposal area, or turn OFF the power and power back ON.
Code: A07
Description: Paper feed error
Causes: 4 10 Paper-ejection sensor was OFF when the paper should have arrived. (Paper misfeed).
Remedy:
Code: A09
Description: Paper ejection error
Causes: 4 11 Paper-ejection sensor was ON when the paper should have left the paper-ejection sensor.