Description: Mechanical total counter error
The mechanical counter is not connected.
Causes: • Mechanical total counter defective
• Mechanical total counter connector not connected
Code: 910 ... 914
Description: External Controller Error
The external controller alerted the machine about an error.
Causes: • Please refer to the instructions for the external controller.
Code: 919
Description: External Controller Error 6
While EAC (External Application Converter), the conversion module, was operating normally, the receipt of a power line interrupt signal from the FLUTE serial driver was detected, or BREAK signal from the other station was detected.
Causes: • Power outage at the EFI controller
• EFI controller was rebooted
• Connection to EFI controller loo
Code: 920
Description: Printer error 1
An internal application error was detected and operation cannot continue.
Causes: • Software defective; turn the machine off/on, or change the controller firmware
• Insufficient memory
Code: 921
Description: Printer error 2
When the application started, the necessary font was not on the SD card.
Causes: • Font not on the SC card
Code: 925
Description: NetFile Function Error
• The NetFile file management on the HDD cannot be used, or a NetFile management file is corrupted and operation cannot continue.
• The HDDs are defective and they cannot be debugged or partitioned, so the Scan Router functions (delivery of received faxes, document capture, etc.), Fabric services, and other network functions cannot be used.( HDD status codes displayed on the debug console are described below.)
Causes: • HDD defective
• Power supply to machine cut occurred while writing data to HDD
• Software error
• Please refer to the detailed descriptions below for recovery procedures.