Description: Machine serial number error Comparison of the product identification code in the machine serial number (11 digits).
Causes: The product identification code in the machine serial number (11 digits) does not match.
Remedy: Re-enter the machine serial number.
Code: SC230-00
Description: FGATE*1: Does not turn ON. GPIO*2 has not been asserted, although the specified time (200 ms) elapsed after setting JOB to be started and reaching the FGAT assert time.
Causes: Control Board (*1)FGATE: Signals used between the controller and the engine in order to send the information about the sub scan length of the page to be printed. (*2)GPIO: A type of input/output terminal
Remedy: Turn the main power off/on.
Code: SC231-00
Description: FGATE*1: Does not turn OFF. GPIO*2 has not been negated, although the specified time (200 ms) elapsed after detecting GPIO*assert and then reaching the expected FGATE negate time.
Causes: * This is an I/O pin. Such I/O pins can be used for a variety of applications, depending on the setting. (*1)FGATE: Signals used between the controller and the engine in order to send the information about the sub scan length of the page to be printed. (*2)GPIO: A type of input/output terminal
Remedy: • Turn the main power off/on.
Code: SC270-00
Description: Write ASIC communication error • When the engine board could not read the Unique ID of the Writing ASIC properly when starting this machine. • When an Error bit occurred in the communication between the engine board and the Writing ASIC.
Causes: The unique ID of the write ASIC was not read normally.
Remedy: • Turn the main power off/on.
Code: SC277-00
Description: LEDA communication error The head type data was read three times in succession