Description: Unexpected Software Error
Software encountered an unexpected operation not defined under any SC code.
Causes: • Software defective • An error undetectable by any other SC code occurred
Code: 995
Description: Machine Type Information Error
After the machine is powered on, a mismatch is detected between the CPM information sent from the controller to the engine and the CPM information specified by the DIP SW settings.
Causes: The B079 (35 cpm) and B082 (45 cpm) use the same controller board, but the DIP SW settings must be set correctly for the machine speed.
Code: 996
Description: FCU board error
FCU board is connected but not ready.
Description: Application function selection error
The application selected by a key press on operation panel does not start or ends abnormally.
Causes: • Software defective • An option required by the application (RAM, DIMM, board) is not installed
Code: 998
Description: Application start error
After power on the application does not start within 60 s. (All applications neither start nor end normally.)
Causes: • Software defective • An option required by the application (RAM, DIMM, board) is not installed
Code: 999
Description: Program download error
The download (program, print data, language data) from the IC card does not execute normally.
Causes: • Board installed incorrectly • BICU defective • IC card defective • NVRAM defective • Loss of power during downloading • Important Notes About SC999 • Primarily intended for operating in the download mode, logging is not performed with SC999. • If the machine loses power while downloading, or if for some other reason the download does not end normally, this could damage the controller board or the PCB targeted for the download and prevent subsequent downloading. If this problem occurs, the damaged PCB must be replaced.