Description: Sheet length is too short With auto feed enabled for sorting, feeding by the detected data size could not be achieved.
Remedy: The sheet length is too short. Set a sheet with an enough length.
Code: 16
Display: ERR 16 AUTO I/F
Description: Command type auto-recognizing failure. When the command type is at “AUTO”, Auto-recognizing is not executable since the communication cannot be interrupted due to the unable of Handshake.
Remedy: 1. If the handshake setting in Host PC is known, set the plotter setting to the setting again. 2. If the application or the driver command type is known, set the command type directly, not by using “AUTO”. 3. When the command type is not known, check the command type by using the dump function then switch the command type directly.
Code: 20
Display: ERR 20 I/O
Description: RS-232C communication error RS-232C interface condition (setting) incorrect.
Remedy: 1. Check the application or the interface condition of Plotter driver then set the plotter setting to the host PC. 2. Use USB I/F.
Code: 20
Display: ERR 20 I/O
Description: RS-232C communication error The use cable incorrect
Remedy: 1. Replace the cable, if not genuine, with a genuine type. 2. Check Cable disconnecting or shorting.
Code: 20
Display: ERR 20 I/O
Description: RS-232C communication error PC circuit failure
Remedy: If the error occurs successively when Plotter is connected and the power is turned to ON in the condition that any application is not started, it may cause a problem on the circuit of PC. (This may be corrected when BIOS is upgraded.)
Code: 20
Display: ERR 20 I/O
Description: RS-232C communication error Main PCB defect
Remedy: Replace Main PCB. If the error occurs when “LOOP BACK” test is executed.