Description: Instruction to move to the outside of the plotting area Moving to the outside of the cutting area was instructed as a result of various compensation settings (for example, distance compensation or axis compensation)
Remedy: 1. On the assumption that compensation will be made, select an appropriate sheet size and create data with the origin selected at an appropriate location. 2. Do not fill the cutting area with data up to the boarders when axial compensation is to be made for registration mark detection or for any other purpose.
Code: n06
Display: ** NO SHEET **
Description: The sheet having been set is a transparent sheet or a sheet with black backing, which the sheet sensor does not react to.
Remedy: Set the sheet sensor to OFF. Perform sheet width detection only and manually set the cutting area.
Code: n07
Display: ** NO SHEET **
Description: Defective sheet sensor
Remedy: If the error is still displayed even after the sheet setting, execute the sensor testing and check the responsibility of sheet sensor. In case of no response, check the connection of sheet sensor then replace it.
Code: n08
Display: *SHEET sensor OFF*
Description: Sheet sensor is disabled This message appears momentarily during sheet detection with the sheet sensor set to OFF.
Remedy: 1. When the sheet detection is performed on detectable sheets, lift the lever up and set the sheet sensor to OFF. 2. When the sheet detection only for the width detection is allowable in keeping the sheet sensor to OFF, no action is required. (in this case, the width detection is only executed.)
Code: n09
Display: PRMchk NG RETRY!
Description: Hash check error at startup The hash check of saved parameters failed at startup. Parameter other than system parameters: Initialize the relevant parameter, and perform hash check again. System parameter: Replace the parameters with the backed up parameters, and perform hash check again.
Remedy: It is no problem if displayed temporally then started without any error. However, check each parameter (Settings/Communication/ Pen/Distance compensation/System) since a part or all of the parameters may be back to the initial values. If displayed whenever the power is turned on, the flash ROM is considered to be defective. Check according to the following procedure. 1. Update the F/W to the latest version. 2. Execute the ROM/ RAM Check 3. Clear all parameters. 4. Replace the Main PCB.
Code: n10
Display: MEDIA SKEW <ENT>
Description: The sheet meandered The amount of sheet skew exceeded the skew check setting value when SKEW CHECK was set to ON by the registration mark setting function. The message suggests that the sheet should be reset.
Remedy: Raise the lever, reset the sheet straight and press the [ENTER] key. Adjust the LED pointer to the mark detection start point as the LED pointer lights up and the step feeding is enabled with the Jog key. Press the [ENTER] key to resume registration mark detection.