Description: 241.00 Paper jam near tray 1. 241.10 Second pick attempt failed from Tray 1 241.12 Second pick from manual feeder, tray 1, or feeder failed when the media was in the source while other sheets were committed to the paper path. 241.16 Failed to feed from tray 1. Pages in the paper path have been flushed to the output bin. 241.17 MISIDENTIFIED SMALL GAP JAM. Engine detected small gap at the manual feeder sensor, attempted to open the gap by stopping the feed rolls, trailing edge was seen at the input sensor, manual feeder sensor is no longer covered. 241.19 Second pick attempted failed from Tray 1, no pages printed since calling a 241.10 or a prior 241.19.
Remedy: Remove the tray and inspect the media path for obstructions. Check the pick rollers. Replace the pick rollers if they are worn or clogged with dust. See “ACM pick tire roller removal”. Also check the wear strips and the manual feeder, and replace if necessary.
Code: 242.00
Description: Paper jam near tray 2.
Remedy: Remove Tray 2 and inspect for obstruction in the paper path. Check the pick tires for wear or paper dust. Replace if necessary. Check the wear strips and replace if necessary.
Code: 242.01
Description: Took too long to ramp up dc feed motor
Remedy: Check the connection with Tray 2. (Lift the printer and re-set it on Tray 2.) If the error persists, then replace Tray 2.
Code: 242.08
Description: Received lots of dc feed interrupts before losing them
Remedy: Check the connection with Tray 2. (Lift the printer and re-set it on Tray 2.) If the error persists, then replace Tray 2.
Code: 242.10
Description: Second pick attempt failed from Tray 2
Remedy: Remove Tray 2 and inspect for obstruction in the paper path. Check the pick tires for wear or paper dust. Replace if necessary. Check the wear strips and replace if necessary.
Code: 242.12
Description: Second pick from manual feeder, tray 1, or feeder failed when media was in the source, other sheets were committed to the paper path.
Remedy: Check the wear strips and replace them if worn.