Remedy: 1. If the message is persistent, perform an NVRAM initialization. 2. If the message persists, replace the DC controller. 3. If the message persists, replace the formatter. 4. If the message persists, replace the ETB assembly. 5. Perform post-repair tests #1, #2, and #3. 6. If the message persists, replace the whole MFP.
Code: -
Display: Cleaning...
Description: The MFP is in cleaning mode.
Remedy: 1. If the message is persistent, perform an NVRAM initialization. 2. If the message persists, replace the DC controller. 3. If the message persists, replace the formatter. 4. If the message persists, replace the ETB assembly. 5. Perform post-repair tests #1, #2, and #3. 6. If the message persists, replace the whole MFP.
Code: -
Display: Invalid entry
Description: Invalid data or response.
Remedy: 1. Verify that the most current firmware is installed on the MFP. Load the most current version if necessary. 2. If the message persists regardless of which button is pressed, replace the control panel. 3. If the message persists, replace the formatter. 4. Perform post-repair tests #1, #2, and #3.
Code: -
Display: Memory is low
Description: The device memory has been almost completely filled or is full.
Remedy: 1. Verify that the most current firmware is installed on the MFP. Load the most current version if necessary. 2. Perform an NVRAM initialization. 3. Add memory to the MFP.
Code: -
Display: Page too complex
Description: The device could not print the current page because of its complexity. NOTE This error occurs most often when printing from a host PC. The printer test page might not produce this error.
Remedy: 1. Verify that the most current firmware is installed on the MFP. Load the most current version if necessary. 2. Perform an NVRAM initialization. 3. Add memory to the MFP.
Code: -
Display: Misprint.
Description: The printed pages have been incorrectly placed on the paper.
Remedy: 1. Verify that the most current firmware is installed on the MFP. Load the most current version if necessary. 2. Perform an NVRAM initialization. 3. Add memory to the MFP.