Causes: An electrical trouble caused by zero cross signal error. Frequency between 43 Hz and 57 Hz could not be detected for 5000 msec or longer.
Remedy: [Related parts] • Harness between the Low-voltage Power Supply PCB (UN01/J322) and the DC Controller PCB (UN04/J22) (Unit of replacement: CABLE, POWER SUPPLY) • Low-voltage Power Supply PCB (UN01) (Unit of replacement: POWER SUPPLY ASSEMBLY) • DC Controller PCB (UN04) (Unit of replacement: DC CONTROLLER PCB ASSEMBLY) [Points to note at work] When checking the harness/cable or connector, perform the following work. 1. Disconnect and then connect the connector to check that there is no bent pin and cable disconnection. 2. Visually check that the harness is not caught or open circuit. 3. If there is any error, replace the corresponding harness/cable. [Remedy] Check/replace the related parts.
Code: E996 0071 ... E996 0CAF
Description: Error for collecting sequence jam log (ADF)
Causes: Error for collecting sequence jam log (ADF)
Remedy: Collect debug log and contact to the sales company. [Reference] By setting “COPIER (LEVEL2)> OPTION> FNC-SW> JMERR- R” to “0” (default), it is handled as a jam, instead of an error.