Description: Fixing Power Supply error
Detect that the Fixing Main Thermistor Unit is not connected.
Remedy: 1. Check the harness of the Fixing Main Thermistor (THM1) in the Fixing Assembly. 2. Check the connection of the harness of the Fixing Assembly on the host machine side. 3. Replace the Main Driver PCB (PCB2).
Code: E005-0000
Description: Fixing Cleaning Web absent error
After noticing the Fixing Cleaning Web absent, the web was pulled out 2000 times.
Remedy: 1. Replace the Fixing Cleaning Web. 2. Replace the Fixing Cleaning Web Level Sensor (PS45). 3. Replace the DC Controller PCB (PCB1). After executing the measures, clear the Fixing Cleaning Web counter (COPIER > COUNTER > MISC > FIXWEB).
Code: E005-0001
Description: Error in Fixing Cleaning Web Drive Solenoid connection
Connection of the Fixing Cleaning Web Drive Solenoid (SL9) is not detected when the power is turned ON.
Remedy: 1. Check the connection of the Connector. 2. Replace the Fixing Cleaning Web Drive Solenoid (SL9).
Code: E005-0010
Description: Fixing Cleaning Web errort error
Turning OFF and then ON the power without clearing the error.
Remedy: Clear the error.
Code: E012-0001
Description: Drum Motor (M1) error
Lock error of the Drum Motor (M1).
Remedy: 1. Check the connection of the Main Driver PCB (PCB2) and the Drum Motor (M1). Motor side: J2138, PCB side: J109 2. Check the voltage of the Drum Motor (M1) J2151. If voltage is 0V, check the connection of the Relay PCB J520. 3. Replace the Drum Motor (M1). 4. Check the gear of the Drum Drive Shaft. If the load is too much, replace the Process Unit and the Drum Drive Unit (Shaft). 5. Replace the Main Driver PCB (PCB2). 6. Replace the DC Controller PCB (PCB1).
Code: E013-0001
Description: Error in Waste Toner Lock Detection Connector disconnection
The Waste Toner Lock Detection Switch (SW5) detects locked state 3 times for 200 msec at power-on.
Remedy: Check the connection of the Waste Toner Lock Detection Switch (SW5) and the Main Driver PCB (PCB2). Switch side: J3050, PCB side: J103