-
Catalog
-
Sign In
-
Contacts
-
Forum
-
Eng
Zebra 140
Error Codes List page 1
|
|
- Code: 01
- Display:
- Description: All LEDs light, but nothing displays on LCD and printer will not operate.
- Causes: Main Logic Board or EPROM faulty.
- Remedy: Insure EPROMs properly installed or Replace the Main Logic Board.
- Code: 02
- Display:
- Description: Buffer Empty LED turns OFF after 15 sec. but all other LEDs stay ON
- Causes: Main Logic Board Dynamic RAM faulty.
- Remedy: Replace Main Logic Board
- Code: 03
- Display:
- Description: ONAll LEDs flash ON and OFF
- Causes: No significant amount of DRAM tested good
- Remedy: Replace the main logic board,
- Code: 04
- Display:
- Description: Take Label LED Flashing
- Causes: Printer Misconfigured for Peel- Off Mode
- Remedy: If Peel-Off is desired, check Take Label Sensor
- Code: 05
- Display:
- Description: Printer locks up while running Power On Self Test
- Causes: Main logic Board failure
- Remedy: Replace Main Logic Board
- Code: 06
- Display: CHECKSUM FOR ROM SET INVALlD
- Description:
- Causes: A ROM checksum is incorrect.
- Remedy: Turn the printer OFF and then ON. If the fault reoccurs, replace the main logic board