Description: N-Up NG Out Of Range During 2-Up or 4-Up, the reduce/enlarge ration was not within the range of 25 to 400%.
Remedy: Press [Stop] on the UI Panel and change the settings.
Code: 003-754
Description: IPS Overrun The IPS processing has overtook the Scan processing.
Remedy: This might be avoided by setting the R/E ratio to 99% or 101%. If this occurs frequently, obtain the document from the User and contact the Support Department for assistance.
Code: 003-795
Description: AMS NG Out Of Range When [Reduce/Enlarge] is set to [Auto], the reduce/enlarge ratio was not within the range of 50 to 200%.
Remedy: Press [Stop] on the UI Panel and change the settings. NOTE: When performing the operation again, the same Fault will occur if the user had proceeded without changing the settings.
Code: 003-942
Description: Not-Supported Doc Size During DADF Scan of a Copy, Scan and Fax sending Job, an unsupported document size was detected.
Remedy: 1. Press [Stop] on the UI Panel. 2. Check the setting of the document size group. 3. Check whether the document size is a supported size. 4. If the document size is a supported size, the DADF might have malfunctioned. Refer to following FIP to check the DADF. • 005-196 (Size Mismatch Jam on No Mix-size) • 005-948 (SS-Size Mismatch Jam on No Mix-size)
Code: 003-956
Description: Not-Supported Doc Size During Platen Scan, an unsupported document size was detected.
Remedy: Press [Stop] on the UI Panel and change the document. NOTE: When performing the operation again, the same Fault will occur if the user had proceeded without changing the document.
Code: 003-963
Description: APS NG Out Of Range During Copy Job, when APS is selected, the image size obtained from document size x reduce/enlarge ratio was detected to be larger than the largest Standard Paper Size.
Remedy: Press [Stop] on the UI Panel and change the settings.