Xerox Phaser 2135
Error Codes List page 10
|
- Code: W12
- Display: W12-Tray 2 Paper Low
- Description: The printer has detected that the paper level in Tray 2 is low. Printing can continue until the tray runs out of paper. Reload the tray as soon as possible to avoid printing interruptions.
- Remedy:
- Code: W13
- Display: W13-Tray 3 Paper Low
- Description: The printer has detected that the paper level in Tray 3 is low. Printing can continue until the tray runs out of paper. Reload the tray as soon as possible to avoid printing interruptions.
- Remedy:
- Code: W16
- Display: Fuse Cut Error
- Description: For the new Customer Replaceable Consumable (imaging drums, transfer belt or fuser) just installed, the printer did not detect the CRC’s “new/used” fuse blow. An internal fuse of a new CRC ordinarily blows a few seconds after the CRC is installed. If the fuse cannot be blown, then the consumable’s counter can't be reset and the “consumable expired / replace” messages will not go away.
- Remedy: 1. Remove the CRC. 2. Cycle the printer’s power. 3. Install the CRC again. If the error still occurs, try a different CRC. 4. If error reoccurs with a different CRC, replace the engine controller board. 5. Replace the print unit chassis.
- Code: W5
- Display: W5-Transfer Belt Near End Of Life
- Description: The transfer belt is near its end of life. Printing can continue until the printer determines that the transfer belt is at its end of life; however, some degradation of image quality may occur. The message remains until interrupted by other messages or until the transfer belt is replaced.
- Remedy:
- Code: W6
- Display: W6-Fuser Near End Of Life
- Description: The fuser is near its end of life. Printing can continue until the printer determines that the fuser is at its end of life; however, some degradation of image quality may occur. The message remains until interrupted by other messages or until the fuser is replaced.
- Remedy:
- Code: W7, W8, W9, W10
- Display: Wn-Drum Near End Of Life [W7-Yellow Drum Near End Of Life] [W8-Magenta Drum Near End Of Life] [W9-Cyan Drum Near End Of Life] [W10-Black Drum Near End Of Life]
- Description: The imaging drum is near its end of life. Printing can continue until the printer determines that the imaging drum is at its end of life; however, some degradation of image quality may occur. The message remains until interrupted by other messages or until the imaging drum is replaced.
- Remedy: