Causes: Feed tray 1 is open. 435 Z09 Feed tray 1 is open. The feed tray 1 set SW is OFF (detection of feed tray open).
Remedy: Close the applicable feed tray. This error is ignored while paper fed from the standard paper feed tray is being printed. or during head maintenance.
Code: Z10
Description: Feed tray 2 not set
Causes: Feed tray 2 is open. 436 Z10 Feed tray 2 is open. The feed tray 2 set SW is OFF (detection of feed tray open).
Remedy: Close the applicable feed tray. This error is ignored while paper fed from the standard paper feed tray is being printed. or during head maintenance.
Code: Z11
Description: Standard paper feed tray check
Causes: The safety SW for the standard paper feed tray is pressed. Or both the Upper and Lower Limit Sensors are activated (too much paper on the tray). 111 Z11 Standard paper feed tray elevator upper limit SW detection The upper limit SW for the standard paper feed tray is turned ON. 112 Z11 Standard paper feed tray overfilled The upper limit sensor and lower limit sensor are turned ON simultaneously for more than 1 second at power ON or during a standard paper feed tray moving operation. 120 Z11 Standard paper feed tray elevator lower limit SW detection The lower limit SW for the standard paper feed tray is turned ON.
Remedy: Deactivate the safety SW for the standard paper feed tray. Remove the overloaded paper from the standard paper feed tray to release the Upper/Lower-Limit Sensor.
Code: Z12
Description: Waste ink tank not set
Causes: The waste ink tank is not set. 322 S96 (Z12) Waste ink tank not installed The waste ink tank is not installed.
Remedy: Set the waste ink tank.
Code: Z13
Description: Ink passage opening failure
Causes: The ink passage opening operation failed. 326 Z13 Ink passage opening failure The ink open sensor fails to activate when the ink fuse solenoid activates. The ink open sensor fails to activate after the ink fuse solenoid activates even after a full one second elapsed. After a retry, the ink open sensor fails to activate even after a full one second elapsed. 341 Z13 Ink open sensor error The ink open sensor deactivates (passage closed) in standby or while printing.
Remedy: Open the ink bottle cover.
Code: Z14
Description: Jam release SW check
Causes: The jam release cover safety SW is OFF. 410 Z14 Jam release SW check The jam release cover safety SW is OFF. * Since the jam release safety SW is shared with the main unit left front cover, this error is seldom displayed.
Remedy: Set the jam release cover safety SW to ON. (Normally, the SW is released when the left front cover is closed.)