Causes: Master positioning sensor is not turned ON at master setting/cutting or at master making even after master has been transferred.
Remedy: Master making unit upper cover set switch: OFF -> ON, and Master positioning sensor: OFF (Reset the master to cancel the error.)
Code: A01 202
Description: • Master positioning is not correct.
Causes: Master positioning sensor is not turned OFF at master setting operation or at the start of master making even if the master roll is rewound for the set period of time.
Remedy: Master making unit upper cover set switch: OFF -> ON, and Master positioning sensor: OFF (Reset the master to cancel the error.)
Code: A01 211
Description: • Master positioning is not correct.
Causes: Master positioning sensor is ON in standby mode.
Remedy: Master making unit upper cover set switch: OFF -> ON, and Master positioning sensor: OFF (Reset the master to cancel the error.)
Code: A01 214
Description: • Master positioning is not correct.
Causes: The Master positioning sensor is ON at the start of master making operation.
Remedy: Master making unit upper cover set switch: OFF -> ON, and Master positioning sensor: OFF (Reset the master to cancel the error.)
Code: A01 215
Description: • Master positioning is not correct.
Causes: The logical value of the sensor at the destination differ from the theoretical value even after the writing PM operation ended due to the sensor stop mode.
Remedy: Master making unit upper cover set switch: OFF -> ON, and Master positioning sensor: OFF (Reset the master to cancel the error.)
Code: A01 258
Description: • Master positioning is not correct.
Causes: The Master end sensor is turned OFF after the master end seal has been detected, and the Master end sensor responses again while the master end is being confirmed.
Remedy: Master making unit upper cover set switch: OFF -> ON, and Master positioning sensor: OFF (Reset the master to cancel the error.)