Description: 200.16 Transport motor error detected 200.17 Took too long to ramp up transport motor
Remedy: Main motor gear drive Main motor cable LVPS/HVPS Controller board Warning: Do not replace the operator panel and controller board at the same time. Each card contains the printer settings. When either of these cards is new, it obtains the settings from the other card. Settings are lost when both are new and replaced at the same time. Turn off the printer, and unplug the main motor cable at J19. Turn on the printer, and check for the following voltages at J19: Verify ground at pin 5 for both the card and cable. •If these voltages are correct, then check the main motor cable for continuity. - Remove the left side cover to access the connector on the motor. - If continuity exists on each wire, then replace the main motor gear drive which includes the motor. - If continuity does not exist on one or more of the wires, then call the next level of support. •If these voltages are not correct, then see “Controller board connector pin values”, or replace the controller board. See “Controller board removal”.
Code: 200.18
Description: Manual feeder sensor never became uncovered from the sheet ahead.
Remedy: Remove the toner cartridge/PC kit. At the front, remove the upper front guide, and inspect the flag on the manual input sensor. If the flag is loose, then replace it. See “Media manual input sensor removal”.
Code: 200.19
Description: The media never reached the input sensor, but was detected at manual feeder sensor.
Remedy: Remove the toner cartridge/PC kit, and inspect for debris in the paper path. Check the bottom of the PC kit for any obstructions. Remove the upper front guide, and inspect the pinch rollers.
Code: 200.20
Description: The media is too long over the manual feeder sensor. Possible causes include multi-sheet feed, media size (length) problem, pre-staged media in the tray.
Remedy: Verify that the media is approved. Inspect the wear strips in the tray, and replace if they are worn.
Code: 200.22
Description: FAILED SMALL GAP OR NO GAP JAM RECOVERY. Engine detected small gap or no gap at the manual feeder sensor, opened the gap by stopping the feed rolls, but never saw the leading edge of the second page at the input sensor.
Remedy: Verify that the media is approved. Inspect the wear strips in the tray, and replace if they are worn.
Code: 200.23
Description: Laser Servo never started due to potential conflict with the transfer servo. Possible causes: slow or missing transport motor positional feedback, or the media is transferred too quickly to the input sensor.
Remedy: Verify that the media is approved. Inspect the wear strips in the tray, and replace if they are worn. Check the main motor.