Description: Fixing Motor (M1) pressure release error
Pressure release had never been detected in 3.0 seconds.
Remedy: 1. Check the connector connection between the Fixing Motor and the DC Controller PCB (J203). 2. Replace the Fixing Motor (M1). 3. Replace the DC Controller PCB (PCB1).
Code: E014-0004
Description: Fixing Motor (M1) pressurization error
Pressurization had never been detected in 3.0 seconds
Remedy: 1. Check the connector connection between the Fixing Motor and the DC Controller PCB (J203). 2. Replace the Fixing Motor (M1). 3. Replace the DC Controller PCB (PCB1).
Code: E020-0000
Description: Detection of toner clog between the Hopper and the Developing Assembly
When the Developing Assembly Toner Sensor (TS2) detected "toner absent" and the Hopper Toner Sensor (TS1) detected "toner-present", the Hopper Motor (M6) was rotated 194 times with intermissions of 1 second, but the Developing Assembly Toner Sensor (TS2) could not detect "toner-present". * If paper is being fed, the error occurs after the paper has been delivered.
Remedy: 1. Check rotation of the Hopper Motor Gear. (If it is rotating, the sensor may not be detecting correctly. In that case, execute Service Mode>CLEAR>ENGIN>TNRINST to supply toner to the Developing Assembly.) 2. Replace the Developing Assembly Toner Sensor (TS2). 3. Replace the Hopper Toner Sensor (TS1). 4. Replace the DC Controller PCB (PCB1).
Code: E024-0000
Description: Connector disconnection of the Developing Assembly Toner Sensor (TS2) or the DC Controller PCB (J209)
Developing Assembly Toner Sensor (TS2) connection detection signals were not detected 10 times in a row in 100 msec. * If paper is being fed, the error occurs after the paper has been delivered.
Remedy: 1. Check the connection of the Connector (J209). 2. Replace the Developing Assembly Toner Sensor (TS2). 3. Replace the DC Controller PCB (PCB1).
Code: E024-0001
Description: Detection of disconnection of the Developing Assembly Toner Sensor (TS2)
At normal speed: Developing Assembly Toner Sensor (TS2) signals were detected 7500 times in a row at intervals of 100 msec. At low speed: Developing Assembly Toner Sensor (TS2) signals were detected 4500 times in a row at intervals of 100 msec.
Remedy: 1. Check the connection of the Connector (J209). 2. Correct the wiring. 3. Replace the Developing Assembly Toner Sensor (TS2).
Code: E025-0000
Description: Connector disconnection of the Hopper Toner Sensor (TS1) or the DC Controller PCB (J211)
Hopper Toner Sensor (TS1) connection detection signals were not detected 10 times in a row in 100 msec. * If paper is being fed, the error occurs after the paper has been delivered.
Remedy: 1. Check the connection of the Connector (J211). 2. Replace the Hopper Toner Sensor (TS1). 3. Replace the DC Controller PCB (PCB1).