Description: When the HOLDING TRAY HOME POSITION signal (THP) is not generated within 4 seconds from the beginning of HOLDING TRAY MOTOR DRIVE command (TMDP1,2) When the HOLDING TRAY HOME POSITION signal (THP) is generated for at least one second while the HOLDING TRAY MOTOR DRIVE command (TMDSP1,2) is being generated.
Code: E203
Description: When two or more clock pulses are not inputted from the SCANNER MOTOR DRIVE command is being generated.
Code: E210
Description: When the LENS HOME POSITION signal (LHP) is not generated within 4.8 seconds after the power switch or door switch goes ON. When the LENS HOME POSITION signal (LHP) is generated for 2 seconds or more.
Code: E243
Description: When an abnormally in communication occurs between the microprocessors on the DC controller PCB and those on the control panel PCB.
Code: E400
Description: When an abnormality in communication occurs between the DC controller PCB detect RDF controller PCB.
Code: E401
Description: When a flag mounted on the pick-up roller HOME position sensor (S3), it indicates that M1 is turning. S3 should go ON and OFF two or more times in one second.