Sharp MXB476W
Maintenance. 2. Display of maintenance execution timing 2
The message of maintenance execution timing is displayed when each counter reaches the set value. The relations between the message and the counters are shown below.
D. Drum unit
Display content | Display condition | Print JOB Enable/ Disable |
||
Sim26-38-A set value | Counter name | Counter value | ||
Maintenance required: DK | 0 (Print continue) | OPC drum print counter OPC drum accumulated rotation counter |
When 100K is reached or When 600K rotation is reached |
Enable |
1 (Print stop) |
* After execution of the maintenance, execute SIM24-4 to clear print counter, the accumulated rotation counter and the use day counter of DRUM UNIT K.
E. Developer
Display content | Display condition | Print JOB Enable/ Disable |
||
Sim26-38-A set value | Counter name | Counter value | ||
Maintenance required: VK | 0 (Print continue) | Developer print counter DV unit accumulated rotation counter |
When 100K is reached or When 600K rotation is reached |
Enable |
1 (Print stop) |
* After replacing developer, execute SIM25-2 to automatically clear counters.
F. Toner
Status | Display content | Display condition | Print JOB Enable/ Disable |
||
Sim26-38-A set value | Counter name | Counter value | |||
Close to Near end (Near naer end) | Toner Low. (Do not replace cartridge until requested.) |
No relation | Toner motor rotation time | Specified time of rotations | Enable |
Near end | Change the toner cartridge. | No relation | Toner supply amount is decreasing | Toner remaining sensor output variation | Enable |
Toner end (End) | Change the toner cartridge. | 0 (Print continue) | The toner remaining counter from near end reaches the specified value | Specified toner remaining counter | Disable |
1 (Print stop) |