Sim No. |
Function |
5 |
1 |
Check the operation of the display, LCD in the operation panel and the control circuit |
2 |
Check the operation of the heater lamp and the control circuit |
4 |
Check the operation of the discharge lamp and the control circuit |
6 |
1 |
Check the operation of the loads in the paper transport system (clutches and solenoids) and the control circuit |
2 |
Check the operation of the each fan motor and the control circuit |
90 |
Setting load move for shipment |
7 |
1 |
Set the operating condition of aging |
6 |
Set the operating intermittent aging cycle |
8 |
Check the warm up time |
8 |
1 |
Check and adjust the operation of the developping voltage in each print mode and the control circuit |
2 |
Check and adjust the operation of the main charger voltage in each print mode and the control circuit |
6 |
Check and adjust the operation of the transport voltage and the control circuit |
9 |
2 |
Check the operation of the sensors in the paper reverse section (duplex section) and the control circuit |
3 |
Check the operation of the loads in the paper reverse section (duplex section) and the control circuit |
10 |
1 |
Check the operation of the toner supply mechanism (toner motor) and the control circuit |
4 |
Toner cartridge motor count sensor check |
14 |
|
Cancel H3, H4, H5 trouble |
16 |
|
Cancel U2 trouble |
21 |
1 |
Set maintenance cycle |
22 |
1 |
Check the print count value in each section and each operation mode |
2 |
Check the total number of misfeed and trouble |
3 |
Check misfeed ppositions and misfeed count of each position |
4 |
Check the trouble history |
5 |
Check the firmware version of each unit |
6 |
Output setting/adjustment data, firmware version and counter list |
9 |
Check the number of use (print counter) of each paper feed section |
10 |
Check the system configuration |
13 |
Check the operation time of the process section (Drum unit, DV unit, toner cartridge) and fusing unit |
14 |
Check the use status of the toner cartridge |
23 |
2 |
Output JAM, trouble history data |
24 |
1 |
Clear JAM counter and trouble counter |
2 |
Clear paper feed counter of each paper feed section |
4 |
Clear maintenance counter and print counter of the transport unit and the fusing unit |
5 |
Clear developer counter |
35 |
Clear used toner cartridge counter |
25 |
1 |
Check the operation of the developing section |
2 |
Set toner density initial level when replacing developer |
4 |
Check toner supply control data |
5 |
Check toner density correction data |
26 |
6 |
Set the destination |
7 |
Set the machine ID |
18 |
Set the toner save mode |
30 |
Set the operation mode corresponding to CE control |
35 |
Set SIM22-4 trouble history when a same trouble occurred repeatedly as one trouble or several time |
38 |
Set print operation when the maintenance life is reached |
49 |
Set the print speed in postcard mode |
50 |
Set the function |
54 |
LCD duty setting |
69 |
Set toner near end operating condition |
73 |
Adjust image enlargement and A3 wide copy |
30 |
1 |
Check the operation of the sensors in other than the paper feed section and the control circuit |