Sharp MX2661
Simulation mode. List of Classic mode. Codes 26-35 - 43-20
Sim No. | Function | Installation | Maintenance | Adjustment and Settings |
---|---|---|---|---|
26-35 | Set the display/mode of SIM 22-4 trouble history when a same trouble occurred repeatedly. There are two display modes. Display as one trouble and display as several series of troubles | |||
26-38 | Set continue/stop of print when the maintenance life is reached | |||
26-41 | Set magnification ratio auto select function in the center binding mode | |||
26-49 | Set the print speed of postcard mode | |||
26-50 | Function setting | 2-1 | ||
26-52 | Set count up mode for non-printed paper | 2-2 | ||
26-65 | Set the finisher alarm mode | 2-1 | ||
26-66 | Set password for simulation | |||
26-69 | Set the operating condition for toner near end | 2-4 | ||
26-73 | Adjust image loss for enlargement copy, A3 wide copy mode | |||
26-74 | Set the OSA trial mode | |||
26-78 | Set password for the remote operation panel | 2-1 | ||
26-79 | Set pop-up display of security | |||
26-85 | Set the function for the simulation mode | |||
27-2 | Set the sender's registration number and the HOST server telephone number | 2-5 | ||
27-4 | Set the initial call and toner order auto send | 2-5 | ||
27-5 | Set the machine tag No. | |||
27-6 | Set of the manual service call | |||
27-7 | Set of the enable, alert callout | 2-5 | ||
27-9 | Set the paper transport time recording Yes/ No threshold value and shading gain adjustment retry number |
2-5 | ||
27-10 | Clear the trouble prediction history information | |||
27-11 | Check the serial communication retry number and the scanner gain adjustment retry number history | |||
27-12 | Check the high density, halftone process control and the auto registration adjustment error history | |||
27-13 | Check the history of paper transport time between sensors | |||
27-14 | Set the FSS function connection test mode | 2-5 | ||
27-15 | Display the FSS connection status | 2-5 | ||
27-16 | Set the FSS alert send | 2-5 | ||
27-17 | Set the FSS paper order alert | 2-5 | ||
30-1 | Check the operation of the sensors in other than the paper feed section and the control circuit | |||
30-2 | Check the operation of the sensors in the paper feed section and the control circuit | |||
30-30 | Check the operation of the motion sensor | |||
40-2 | Adjust the paper width sensor of the manual paper feed tray | 4 | ||
40-7 | Set the adjustment value of the paper width sensor of the manual paper feed tray | |||
41-1 | Check the operation of the document size sensor and the control circuit | 3 | ||
41-2 | Adjust the document size sensor detection level | 3 | ||
41-3 | Check the operation of the document size sensor and the control circuit | |||
43-1 | Set the fusing temperature in each mode | |||
43-2 | Set the fusing operation and preheating | |||
43-20 | Set the environment correction under low temperature and low humidity (L/L) for the fusing temperature setting (SIM43-2) in each paper mode |