Brother MFC-J6535DW
Maintenance Mode. 02. Error No
Note:
If an error occurs, the machine beeps and displays "Error No **" on the LCD. Press the Stop key to return to the initial stage of the maintenance mode and then recover the machine from the error state, following the table given below. Then go back to step (3).
Error code | The following error has occurred. | Do the following: |
---|---|---|
01 | Failed to detect the external frame. |
|
02 | Internal image inclined. | |
03 | Failed to detect position. | |
04 | Failed to write head calibration data. |
|
05 | The uneven printing correction function for upper and lower ends of the nozzle is disabled with Maintenance 88. | - Set selector 1 on AMS05 to "0" (ON) in “1.3.34 Assurance Mode Switch Setting (Maintenance mode 88)” in this chapter. |
06 | Cannot get data due to memory full. |
|
07 | The document scanner unit is open. |
- Replace the main PCB. |
09 | Scanning errors other than the above. | - Use “1.3.15 Acquisition of White/Black Level Data (Maintenance mode 55)” in this chapter. |
10 | With a media being inserted, the USB cable or LAN cable is connected. | - Disconnect the USB cable or LAN cable. |
11 | The scanner cover is open. | - Close the scanner cover. |