Page 1 of 1

Canon iR3320i error E007-0000

Posted: Mon Oct 23, 2017 9:37 pm
by Alvaro
My machine Canon iR3320i have error E007-0000. How do I fix this error code.

Re: Canon iR3320i error E007-0000

Posted: Mon Oct 23, 2017 9:44 pm
by Serviceman
E007 0000
An error in the rotation of the fixing film is detected. The reading of the main thermistor is 100°C or higher and, in addition, the fixing film sensor does not detect the rotation of the film for 6 sec or more while the fixing motor is driven.
Cause: The fixing film sensor (PS45) is faulty. The DC controller PCB is faulty.
Caution: To clear the error, execute the following in service mode: COPIER>FUNCTION>CLEAR>ERR.
Solution:
1. Wiring
Are the wring and the connectors connected securely? DC controller PCB (J311) <-> relay connector <-> fixing film sensor NO: Connect the wiring and the connectors.
2. Fixing film sensor
Check the fixing film rotation signal. When the fixing motor is rotating, is the film rotation detection signal sent by the fixing film sensor to the concoctor J311 of the DC controller PCB? Film rotation detection signal: 5V pulse signal between J311-A9 (FILM_ROT_D) and J311-A8 (GND); at intervals of 100 msec ON and 440 msec OFF
NO: If the fixing film is normal, replace the sensor.
3. Fixing film unit, DC controller PCB
Is there a fault in the fixing film edge rotation detection mechanism?
YES: Replace the fixing film unit.
NO: Replace the DC controller PCB.

Canon iR3320i error E007 0000

Posted: Sun Dec 30, 2018 10:30 am
by WarnerRix
acabo de abrir la caja de la Canon 7 d para probarla, y me da error 20. Estoy muy mosqueado. Alguien puede informarme?

Gracias.

Canon iR3320i error E007 0000

Posted: Sun Feb 03, 2019 5:19 am
by TimothywaB
Ive been trying to capture some slow-motion in 1280x720 60fps and a high shutter speed, but getting a lot of ERROR and having to take the battery out and back in. Is this a characteristic of Magic Lantern, or just a limitation of the Canon 60D?

Canon iR3320i error E007 0000

Posted: Thu Mar 21, 2019 12:27 am
by Henryemiva
Update: The error got so bad that the camera would not take a photo at all. So I sent it to a local Vancouver Island camera repair shop as Canon Canada is across the continent in Ontario. The tech told me the shutter had failed, so they are putting in a new one.It will cost about half what used D7s are selling for right now, so Im good with that. I will have essentially a new D7 again.

Canon iR3320i error E007 0000

Posted: Tue May 14, 2019 9:01 pm
by byronFreno
Hi All,
Went to use my Canon 24-105 L lens today and got the dreaded error01 message.
Is there anywhere in Ireland that can repair this at a reasonable cost? It is my favourite walk around lens and I cant afford to replace it at the minute.

Thanks in advance,
Jim

Canon iR3320i error E007 0000

Posted: Thu Dec 19, 2019 7:32 pm
by Jaimemorma
Ive had my G12 four years, well over 100,000 shots, just had the Lens Error problem come up. I too would like to get it repaired, or figure out how to replace the lens unit? It has been my workhorse general camera, especially tor time-lapse sequences and I will miss it sorely. Ill follow the thread...