Toshiba e-Studio 2523A, 2523AD, 2323AM, 2823AM, 2329A, 2829APrecautions for image missing width on the paper trailing edge at enlargement copyingPhenomenon
The bottom margin may disappear and the image is sometimes missing if an A4-size original is copied to an A3-size sheet by enlarging the size.
The range of the bottom margin at actual-size copying is 2.0 mm +/- 1.0 mm (measured value).
However, if this tolerance is located in the minus direction (bottom margin: 1 mm or 0 mm), this phenomenon will easily occur.Countermeasure
When this phenomenon has occurred during enlargement copying, adjust the image dimension using the following procedure.Procedure:
- Perform image dimensional adjustment (bottom margin adjustment) by aligning the value to the center one (2.0 mm).
* The value must be aligned to the center one. No tolerance value +/- 1.0 mm is included.
- Adjust the secondary scanning data laser writing start position by aligning the value to the center one (52 mm) in 05-4058 (drawer) and 05-4061 (bypass tray).
* The value must be aligned to the center one. No tolerance value +/- 0.5 mm is included.