Ricoh Pro C751

Peter
Posts: 57
Joined: Sat Oct 21, 2017 9:46 pm

Ricoh Pro C751

Postby Peter » Tue Feb 02, 2021 10:26 pm

Ricoh pro 751 Error code SC449. How reset it.
Phillip
Posts: 56
Joined: Sat Oct 21, 2017 9:48 pm

Re: Ricoh Pro C751

Postby Phillip » Fri Feb 05, 2021 10:05 am

How can I fix an code SC280 on Ricoh pro c751?
User avatar
Serviceman
Posts: 105
Joined: Sat Oct 21, 2017 9:37 pm

Re: Ricoh Pro C751

Postby Serviceman » Wed Feb 24, 2021 8:05 am

Peter wrote:Ricoh pro 751 Error code SC449

Code: SC449
ITB Tray Lift (K) Error
Cause:
The 2nd lift motor (K) was operating but 2nd lift motor sensor 1 or 2 failed to detect the position of the sensor feeler for the 2nd lift tray (K) within the prescribed time.
Note: There are two lift sensors for the 2nd lift tray below the K_PCDU.
Sensor 1 is above the 2nd lift motor near the front of the ITB unit.
Sensor 2 is at the rear left corner of the ITB unit below the ITB.
Solution:
  • Sensor 1 or 2 dirty
  • Sensor harness disconnected or broken
  • Sensor 1 or 2 defective
  • 2nd lift motor (K) defective
User avatar
Serviceman
Posts: 105
Joined: Sat Oct 21, 2017 9:37 pm

Re: Ricoh Pro C751

Postby Serviceman » Wed Feb 24, 2021 8:09 am

Phillip wrote:How can I fix an code SC280 on Ricoh pro c751?

Code: SC280
IPU Image Transfer Error An error occurred during data sending between components (GRIFFON, LEO) on the IPU board.
Cause:
  • Cycle the machine off/on
  • If the problem persists, replace the IPU
itsonlypaper4print
Posts: 1
Joined: Sat Feb 26, 2022 10:10 am

Re: Ricoh Pro C651

Postby itsonlypaper4print » Sat Feb 26, 2022 10:13 am

Hi

I had a error code 482 can anyone help me

Return to “Ricoh common”

Who is online

Users browsing this forum: No registered users and 1 guest