Kyocera FS1025MFP

Innocent
Posts: 26
Joined: Mon Feb 01, 2021 12:58 pm

Kyocera FS1025MFP

Postby Innocent » Tue Feb 02, 2021 3:38 am

Kyocera 1025
Troubleshooting in image back ground black noising but full contrasting in noun.
Alvaro
Posts: 45
Joined: Sat Oct 21, 2017 9:55 pm

Re: Kyocera FS1025MFP

Postby Alvaro » Thu Feb 11, 2021 11:58 pm

Kyocera printer FS 1025 has error C4000
How do I clear it?
Zeeshan
Posts: 28
Joined: Mon Feb 01, 2021 1:03 pm

Re: Kyocera FS1025MFP

Postby Zeeshan » Sat Feb 27, 2021 4:41 pm

Innocent wrote:Kyocera 1025
Troubleshooting in image back ground black noising but full contrasting in noun.

Spots are printed. Printing incomplete or out of position
  1. Dirty contact glass. Clean the contact glass.
  2. Dirty or flawed drum. Perform the drum refresh.
    Flawed drum. Replace the drum unit
  3. Deformed or worn cleaning blade in the drum unit.
    Replace the drum unit
  4. Main charge voltage setting.
    The main charge voltage may be set too low. Try adjusting the main charge voltage
  5. Defective transfer bias output.
    Defective high voltage PWB. Replace the high voltage PWB
    Defective main PWB. Replace the engine PWB
  6. Flawed developer roller. Replace the developer unit
  7. Dirty heat roller and press roller. Clean the heat roller and press roller.
Zeeshan
Posts: 28
Joined: Mon Feb 01, 2021 1:03 pm

Re: Kyocera FS1025MFP

Postby Zeeshan » Sat Feb 27, 2021 4:45 pm

Alvaro wrote:Kyocera printer FS 1025 has error C4000

Code: 4000
Polygon motor synchronize error
Polygon motor is not stabilized within 15 s since the motor is activated. After polygon motor is stabilized, the ready signal is not detected for 7 s continuously.
Cause:
  • Defective connector cable or poor contact in the connector.
  • Defective polygon motor.
  • Defective main PWB.
Solution:
  1. Defective connector cable or poor contact in the connector.
    Reinsert the connector. Also check for continuity within the connector cable. If none, replace the cable.
  2. Polygon motor and main PWB (YC17)
  3. Defective polygon motor.
    Replace the laser scanner unit .
  4. Defective main PWB.
    Replace the main PWB and check for correct operation .

Return to “Kyocera FS”

Who is online

Users browsing this forum: No registered users and 2 guests