Lexmark CX517

Lexmark printers, copiers
Tadeus
Posts: 58
Joined: Sat Oct 21, 2017 9:43 pm

Lexmark CX517

Postby Tadeus » Fri Nov 05, 2021 10:07 pm

Lexmark CX310, CX317, CX410, CX417, CX510, CX517de, XC2130, XC2132 MFPs
Entering the Diagnostics menu
  1. Turn off the printer.
  2. Press and hold 3 and 6 while turning on the printer.
  3. Release the buttons when the splash screen appears.
Tadeus
Posts: 58
Joined: Sat Oct 21, 2017 9:43 pm

Re: Lexmark CX517

Postby Tadeus » Fri Nov 05, 2021 10:09 pm

Lexmark CX310, CX317, CX410, CX417, CX510, CX517de, XC2130, XC2132 MFPs
Quick Test
The Quick Test contains the following information:
  • Print registration settings
  • Alignment diamonds at the left, right, top, and bottom
  • Horizontal lines to check for skew
  • General printer information, including current page count, installed memory, serial number, and code level
Note: Print the Quick Test Page on letter or A4 paper.

  1. Select Registration from Diag Menu, and press Select.
  2. Select Quick Test Page, and press Select.
    The message Printing... appears on the display.
    Once the Quick Test Page completes printing, the Registration screen displays again.
Tadeus
Posts: 58
Joined: Sat Oct 21, 2017 9:43 pm

Re: Lexmark CX517

Postby Tadeus » Fri Nov 05, 2021 10:14 pm

Lexmark CX310, CX317, CX410, CX417, CX510, CX517de, XC2130, XC2132 MFPs
Motor Detect
This test initiates an automatic motor detection process that should be performed whenever the controller board is replaced.
To run Motor Detect:
  1. Remove the imaging unit and the waste toner bottle.
  2. Reinstall the right cover assembly.
  3. Close the front door.
  4. Enter Diagnostics menu.
  5. Select MISC TESTS in the Diag Menu, and press Select.
  6. Select Motor Detect, and press Select.
    If you press Select before closing the front cover, then a message appears: Close Cover. Press Select.
    Motor Detection In Progress… appears.
    The motor detection process takes about 10 seconds, and stops automatically.
    Detect Complete. Rebooting… appears, and the printer performs a POR (Power On Reset).
    If the motor ran, the test was passed. If the motor did not run, the test failed.

Return to “Lexmark”

Who is online

Users browsing this forum: No registered users and 2 guests