Xerox WorkCentre 7346

Certain diagnostic routines and reports are available locally (on the UI) through CE mode.

Entering

To enter the CE mode:

1. Press and hold the 0 key for 5 seconds, then while still holding down the 0 key, press the Start button. The CE Access Number screen will appear.
2. Enter 6789 and press Confirm.
3. The top most area of the UI display will be reversed to let the user know that the mode has changed to the CE mode.

NOTE:
If a system failure has occurred when the machine is turned ON but it has not been repaired, the diagnostic procedures described in this section may not operate correctly.

Functions enabled in CE mode

Functions available in CE mode can be divided into two groups; Diagnostics and Reports

• UI Diagnostics: Several diagnostic routines are available (see Accessing UI Diagnostics).
• Printable Reports: Several machine history reports can be printed in CE mode, one for example is the HFSI Report, select the link below. These reports are in addition to the reports normally available in System Admin mode (see Printing CSE Reports).

Exiting

There are three ways to exit from CE mode:

• Switch the power Off then On (If actions performed in CE mode cause the machine to restart upon exiting, the machine will come back up in normal user mode).
• Press and hold the 0 key then press the Start button.
• Select Abort the Operation and Exit on the Maintenance/Diagnostics screen.