Xerox WorkCentre 7235
Service Mode 02. Accessing UI Diagnostics
The procedure for entering UI Diagnostics differs, depending on whether the machine is a 72XX-series, or a 73XX series.
Procedure (72xx machines)
- Enter the CE mode (Entering and exiting CE mode).
- Press the Log in/Out button on the control panel. The System Settings screen appears.
- Select System Settings on the UI screen.
- Select Common Settings
- Select Maintenance / Diagnostics.
Procedure (73xx machines)
- Enter the CE mode (Entering and exiting CE mode).
NOTE: If a fault code requiring serial number resychronization (124-3xx) is active, the following steps will not work. Press the Log In/Out button on the UI to access diagnostics in this situation - Press the Machine Status button on the control panel.
- Select the Tools tab on the UI screen.
- Select System Settings.
- In the Group column, select Common Service Settings
- In the Features column, scroll down to Maintenance / Diagnostics.
Maintenance/Diagnostics menus
The following selections will appear:
- Initialize Hard Disk
- Delete All Data
- Software Options
- Initialize NVM
- NVM Read/Write
- Print Test Patterns
- IO Check - this selection opens the following menu:
–Component Control
–Analog Monitor - Registration - this selection opens the following menu:
–Regi Control Setup Cycle - this selection opens the following menu:
Regi Control Setup Cycle - Fine Skew Setup
Regi Control Setup Cycle - IN / OUT Setup
Regi Control Setup Cycle - Center Setup
Rough Skew Setup
–Regi Measuring Cycle
–Regi Control Sensor Check Cycle
–Regi Control Correction Check Cycle - MAX Setup - this selection opens the following menu:
–IIT Calibrations - this selection opens the following menu:
White Reference Setup
CCD Calibration
Optical Axis Correction
–ATC Sensor Setup
–TRC Adjustment
–Adjust Toner Density - this selection opens the following menu:
TRC Control
Adjust Toner Density
–ADC AGC Setup
Measured ADC
Change ADC Target Value - Sub System - this selection opens the following menu:
–Belt Edge Learn
–Fax Diagnostics
–Blank Page Threshold Value
–ADF Independent Operations
–Hard Disk Failure Prediction Test - Faults - this selection opens the following menu:
–Jam Counters
–Failure Counters
–Shutdown History - Adjustments / Others - this selection opens the following menu:
–Machine ID / Billing Data
–Initialize HFSI Counters