Xerox WorkCentre 6655

Purpose

Provide instruction on how to properly switch printer power On or Off. The printer is equipped with both an on/off switch and a Power button on the Control Panel. Normally the Power button is used to power the printer On and Off. However, when service procedures require you to cycle system power or perform procedures that would expose you to the potential for electrical shock, use the shutdown procedure below.

CAUTION

Do not disconnect the Power Cord or interrupt the electricity supply before power down is complete. Data and software can become corrupted.

1. Press Power on the Control Panel. A confirmation window will open.
   NOTE: If the machine is in power save mode, the machine will exit to Ready To Scan before commencing the switch off procedure. If the machine is in software upgrade mode, a message is displayed to warn against switching off the machine.
   NOTE: If the Control Panel is unavailable, the power down request cannot be confirmed. The printer powers down automatically after 60 seconds
2. Confirm by selecting Power Down.
   NOTE: If Power is pressed again before either confirm has been selected or 60 seconds has elapsed, power off is cancelled. The printer returns to normal operation.
3. When a standard power off has been initiated:
   • Control Panel screen goes blank (Black screen).
   • Power Saver LED blinks for approximately 25 seconds.
   • Go off line and stop receiving jobs.
   NOTE: The printer will attempt to print the current sheet and send all sheets in the paper path to the output tray.
   • Stop processing any remaining jobs in the print queue.
   • Send the scan carriage assembly to the home position.
4. When the printer has entered Power Saver mode, switch the on/off switch to the Off position and remove the Power Cord.
5. Wait at least 1 minute following removal of the Power Cord to allow the power supplies to completely discharge before beginning any service procedure.

Switch On Procedure

1. After a power down, wait a minimum of one minute before the printer is switched on.
2. After a service call, ensure that all service tools are removed from the printer.
3. Connect the Power Cord from the AC supply outlet to the printer.
4. Switch the on/off switch to the On position.
5. Press the Power button on the Control panel. The following occurs:
   • The Interrupt button blinks during POST testing. POST checks that the hardware resources are available to run the operating system. If a POST fault is detected, the machine is prevented from booting.
   • The Interrupt button stops blinking as the operating system begins to load. A progress bar and software version information is displayed during loading.
   • If enabled, a Configuration Report is printed.
   • The Services home screen is displayed.
6. The machine is ready to print.
7. If the machine switches on, but the Control Panel is blank, go to the OF 2 Control Panel Touch Screen Failure RAP