Xerox WorkCentre 5330

Purpose

This routine outputs test patterns from the built-in Pattern Generator.

NOTE: An error message is displayed if the print cannot be made with the specified tray. Make sure that there is sufficient paper in the trays before starting the routine. If a jam or system fault occurs, the process stops but a recovery message is not displayed. The fault code is displayed but it is not recorded in History.

Procedure

1. Enter UI Diagnostics (Accessing UI Diagnostics).
2. Press the Machine Status button on the Control Panel.
3. Select the Tools tab on the UI screen.
4. System Settings and Common Service Settings will be selected and displayed.
   NOTE: In order to print some test patterns correctly, you first will have to modify the NVM setting(s) associated with those test patterns. There are three NVM locations that affect test pattern printing: 870-207, 870-209, and 870-210. (Refer to Table 1). Always check the Required NVM Settings column in Table 2 before attempting to print any built-in test pattern.
5. In the Features column, scroll to and select Maintenance / Diagnostics.
6. To print a test pattern that first requires NVM changes, perform a and then b below. To print a test pattern that does NOT require NVM changes, skip a and perform b.
   a. If you must change one or more of the NVM settings for the test pattern you wish to
   print:
   i. Select NVM Read / Write.
   ii. Enter the required NVM Chain-Link(s) and the setting(s) shown in Table 2.
   iii. Save the new setting(s).
   iv. Close the routine to return to the Maintenance / Diagnostics menu.
   v. Continue at b.
   b. On the Maintenance / Diagnostics menu select Print Test Pattern, enter the Pattern
   Number, the Quantity, and select the Paper Supply, then press Start.

NOTE: To switch from a test pattern that requires one set of NVM values to a test pattern that requires a different set of values (on none), you must exit UI Diagnostic mode and allow the machine to reboot before entering the new NVM values (Exiting the Service Rep. Mode and rebooting the machine causes the NVM values to reset to their defaults.)