Xerox WorkCentre 5330

Procedure

1. Enter the Service Rep. Mode (Entering and Exiting Service Rep. Mode).
2. Press the Machine Status button on the control panel
3. Select the Tools tab on the UI screen.
4. System Settings and Common Service Settings will be highlighted.
5. In the Features column, scroll to and select Maintenance / Diagnostics.

Maintenance/Diagnostics Menus

The following selections will appear (on 1st page):

• Quick Setup Home
  – IP Address Settings
  – Security Settings
  – E-mail Settings
  – LPAD Settings
• Software Options
• NVM Read/Write
• Initialize Hard Disk
• Print Test Patterns
• Delete All Data
• Initialize NVM
  – IOT
  – Output (Finisher)
  – IISS (IIT/IPS)
  – IISS - Extension
  – Input Device
  – Sys - SYSTEM
  – Sys - USER
• The following selections will appear (on 2nd page): IO Check - this selection opens the following menu:
  – Component Control
  – Analog Monitor
• Sub System - this selection opens the following menu:
  – ADF Independent Operation
  – Hard Disk Failure Prediction Test
• Adjustments / Others - this selection opens the following menu:
  – Machine ID/Billing Data
  – HFSI Counter
  – Finishers - Adjust Hole Punch Position and Booklet Crease/Staple Position (LX Finisher only - see ADJ 12.1 and ADJ 12.2)
• Registration - this selection opens the following menu:
  – Tray 5 Guide Adjustment
  – System Registration Adjustment
• Faults - this selection opens the following menu:
  – Jam Counter
  – Failure Counter
  – Shutdown History
• Restore NVM Values
• MAX Setup - this selection opens the following menu:
  – Adjust Toner Density (ADJ 9.4)
  Measure Sensor State
  Adjust Toner Density
  – IIT Calibration- this selection opens the following menu:
  White Reference Adjustment
  CCD Calibration
  Optical Axis Correction (ADJ 6.1)
• The following selections will appear (on 3rd page):
  – USB Key
  – Power On Self Test
  Off
  On
  – Delete All Certificates / Initialize Settings