-
Catalog
-
Sign In
-
Contacts
-
Forum
-
Eng
Xerox WorkCentre 220
Troubleshooting. Abnormally low fusing temperature
Detection Timing
- The temperature detected by the Thermistor remains lower than the set temperature continuously for a predetermined period of time while the fusing temperature control is being provided. (The set temperatures are as follows: 140 °C during a print mode at 600 dpi; 110 °C during a print mode at 1200 dpi; 70 °C during the standby mode.)
Relevant Electrical Parts
- Fusing Unit
- Thermistor (TH1)
- Fusing Roller Heater Lamp (H1)
- Controller/Mechanical Control Board (PWB-P)
- Thermostat (TS1)
- Power Unit (PU1)
Troubleshooting Procedures
Step |
Action |
Control Signal/ Location |
1 |
Replace Thermistor (TH1). |
|
2 |
Replace Fusing Roller Heater Lamp (H1). |
|
3 |
Replace Thermostat (TS1). |
|
4 |
Replace Fusing Unit. |
|
5 |
Replace Controller/Mechanical Control Board (PWB-P). |
|
6 |
Replace Power Unit (PU1). |
|