-
Catalog
-
Sign In
-
Contacts
-
Forum
-
Eng
Xerox WorkCentre 220
Troubleshooting. Warm-up failure
Detection Timing
- The voltage of the Thermistor remains low for a predetermined period of time when a warm-up cycle is started.
- The temperature detected by the Thermistor remains lower than a reference value for a predetermined period of time for the period of time that begins 5 sec. after, and ends 9 sec. after, the start of the warm-up cycle (where the temperature detected by the Thermistor is 80 °C or less).
- The temperature detected by the Thermistor does not increase for a 3-sec. period or more for the period of time that begins after the lapse of a predetermined period of time after the Fusing Roller Heater Lamp has been turned ON and ends when the lamp is turned OFF.
- The Fusing Roller Heater Lamp remains ON for a 30-sec. period or more (except during the period through which the Main Motor remains energized).
Relevant Electrical Parts
- Fusing Unit
- Thermistor (TH1)
- Fusing Roller Heater Lamp (H1)
- Controller/Mechanical Control Board (PWB-P)
- Thermostat (TS1)
- Power Unit (PU1)
Troubleshooting Procedures
Step |
Action |
Control Signal/ Location |
1 |
Replace Thermistor (TH1). |
|
2 |
Replace Fusing Roller Heater Lamp (H1). |
|
3 |
Replace Thermostat (TS1). |
|
4 |
Replace Fusing Unit. |
|
5 |
Replace Controller/Mechanical Control Board (PWB-P). |
|
6 |
Replace Power Unit (PU1). |
|