Xerox Phaser 3010

These tests check whether the Digital Output (DO) components (motors, clutch, and solenoids) operate. When the interlock is opened during a Motor Test the component stops.

When a paper jam or PQ problem occurs, or an error message or code is displayed, these tests help to pinpoint the faulty part. Before executing the test, examine the details of the jam, print quality problem, or error, and isolate the faulty parts. These tests are available:

• Main Motor (Full, Slow)
• Feed Solenoid
• Toner Motor

DO-1 Main Motor (Full Rotation)
DO-2 Main Motor (Slow Rotation)
DO-6 Feed Solenoid
DO-9 Toner Motor

Main Motor

Caution
Run the for 10 seconds or longer may cause damage to the printer.

1. Enter Service Diagnostics
2. Use the Up and Down Arrow buttons to select Printer > IOT Diag > Digital Output > DO-1.
3. Check that the Exit Roller rotates.
4. Press the Stop button to stop the test.

Feed Solenoid

The Feed Roller rotates when the DO-1 (Main Motor) and the DO-6 (Feed Solenoid) tests are executed simultaneously.

1. Enter Service Diagnostics
2. Remove the Bypass Tray.
3. Run the Main Motor Full and Feed Solenoid tests.
4. Check that the Feed Roller rotates.
5. Press the Stop button to stop the Feed Solenoid test.
6. Use the Down Arrow to scroll to the motor test and press Stop to stop the motor test.

Toner Motor

1. Enter Service Diagnostics
2. Open the Front Door.
3. Remove the Toner Cartridge.
4. Run the Toner Motor test: Printer > IOT Diag > Digital Output > DO-9
5. Check that the toner auger rotates.
6. Press the Stop button to stop the test.