Xerox CopyCentre C2636

This RAP is used when Skew, System Registration, or Magnification are out of specification. For Color-to-Color-Misregistration, go to the IQ8 RAP.

Initial Actions

• Load some new, dry 24 lb. 11X17/A3 Xerox COLOR Xpressions (NASG), or 90 GSM Colortech + (ESG) into each paper tray (use 8.5X11/A4 in Tray 1). Make 3 full color copies from each paper tray. Mark the appropriate paper tray on these copies.

Procedure

	Procedure	Yes	No
1	The problem is still present when using the proper paper.	3	2
2	Explain to the customer that new, dry, 24 lb. Xerox COLOR Xpressions (NASG), or 90 GSM Colortech + (ESG) paper is the specified paper for use in the DocuColor 1632/2240.
3	The problem occurs only in the printer mode.	19	4
4	The defect occurs when the document is manually registered on the platen glass.	6	5
5	Ensure that the Document Transport Belt is clean. Check the Document Handler Adjustments (ADJ 5.1 through ADJ 5.6). If the problem continues, check the DADF drive rolls and pinch rolls for wear or glossing.
6	The problem is Skew	16	7
7	The problem is Misregistration	9	8
8	Adjust the IIT Vertical/Horizontal Magnification (ADJ 9.12) and the IOT Lead Edge/Side Edge Registration (ADJ 9.9).
9	Enter dC612. Select Pattern 3. Misregistration is present on the copy	11	10
10	Adjust the IOT Lead Edge/Side Edge Registration (ADJ 9.9), then the IIT Lead Edge and Side Edge Registration (ADJ 9.10 and ADJ 9.11).
11	The defect occurred on copies from all five paper trays.	13	12
12	Check the IOT Lead Edge/Side Edge Registration (ADJ 9.9) for that tray. Check the feeder for the affected tray for wear, slipping, damage, or contamination. • Tray 1 Feeder (PL 2.4) • Tray 2 Feeder (PL 16.7) • Tray 3 Feeder (PL 16.9) • Tray 4 Feeder (PL 16.11) • Tray 5 Feed Assembly (PL 2.14)
13	Registration varies from copy to copy.	15	14
14	Go to ADJ 9.9, Lead/Side Edge Adjustment.
15	Check the components in the Registration Transport Assembly (PL 2.6) for wear, slipping, damage, or contamination. Clean/replace as required
16	The defect occurred on copies from all five paper trays.	18	17
17	Check the components in the Registration Transport Assembly (PL 2.6) for wear, slipping, damage, or contamination. Clean/replace as required
18	Check the IOT Lead Edge/Side Edge Registration (ADJ 9.9) for that tray. Check the feeder for the affected tray for wear, slipping, damage, or contamination. • Tray 1 Feeder (PL 2.4) • Tray 2 Feeder (PL 16.7) • Tray 3 Feeder (PL 16.9) • Tray 4 Feeder (PL 16.11) • Tray 5 Feed Assembly (PL 2.14)
19	The problem occurs on all jobs.	21	20
20	Have the customer re-evaluate affected jobs and resend.
21	Refer to the DFE Service Guide.